The SC100 controller is a low cost, simple to use simplex or duplex controller for lift station liquid level control. It operates the pumps based on the selected setup parameter values and the 4-20 mA wet well level input signal. The controller has relays for two pump call outputs, and for high and low level alarms outputs. A regulated 24 VDC power supply is provided for powering the pressure transducer circuit. A four digit seven segment red LED display is provided for parameter setup and level display. Red LED’s are provided for pump 1 and 2 call and for high and low level alarm indication. Alternation of the pumps is provided, and a fixed 1-2 or 2-1 sequence may also be selected through the menu. The controller can be setup to perform either pump up control (fill a tank) or pump down control (empty a tank). It also has a fixed 10 second power-up delay, and an adjustable lag pump delay to prevent the turning on of one or both of the pumps immediately after a power interruption. Zero and Span parameters are provided for field calibration of the level input for a wide variety of submersible pressure transducers. The level display is made even more flexible by the addition of a parameter to set the decimal point position, and by a parameter to adjust how fast the level display responds to changes in the level input signal, from very slow to fast. A level simulation feature is provided to test the lift station controls and pump operation.