If you don't find what you are looking for, please call MPE at 407-299-3825.
View Cart View RFQs Express Ordering
 Shopping Cart 0 Items
 Request for Quote 0 Items
All Categories > Special Controls > Automeg Automatic Insulation Testers > View Items  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Automeg Automatic Insulation Testers

Check up to five results to perform an action.

When power is applied, the power LED comes on. When a motor start signal is applied to pin 3, the middle LED comes on, showing that the 500 VDC is being applied to the motor winding. If the winding is good, the Automeg completes the megging operation, and the motor starts signal is then connected from pin 3 to 4.

If the winding is bad, the Low Meg LED comes on, and the motor start signal will not be available at pin 4 to engage the motor starter. To unlatch the Low Meg alarm contact, depress the Motor Reset pushbutton. The Low Meg Alarm contacts, pins 10 and 11, are a normally open relay contact that closes upon the Low Meg Alarm condition.

An Emergency Bypass Switch is provided to bypass the megging process. Placing this switch in the bypass mode disables the megging circuit, and engages the motor start relay circuit, pins 3 and 4.

The Meg Test Button is used to verify that the Automeg unit will provide an indication for a Low Meg condition should the condition occur.

The Meg test is used to check the low Meg condition when there is no start signal applied. If the start signal is present, the Meg test circuitry is disable.




Add To Cart Request Quote
   
  Results 1 - 1 of 1 1 

Item #

Item Name

Alternating Current (AC) Input Voltage

Frequency

Current

List Price

AUTOMEG Automeg Automatic Insulation Tester 120 V 50 to 60 Hz 5.9 V·A QUOTE
  Results 1 - 1 of 1 1 
Site created by Thomas Web Solutions and powered by Navigator Platform
Motor Protection Electronics, Inc. | Leaders in Design and Manufacturing for Industrial Controls